Control Of The Aiv Dvb-T-Tuner 190860 With Porsche Pcm2.1 - IMU 670848 Bedienungsanleitung

7. Connect RCA jacks - A: audio left (black), B: audio right
(red), with the audio output of the video source. The
yelllow RCA jack (C) is only used when the video source
delivers a NTSC signal. Information on connection can
also be found on page 21. Connection with the video
source should only be done with a high quality RCA video
cable, otherwise the picture quality could be bad, caused
by a weak video signal. The video output signal (CVBS) is
fed into the head unit directly by using the enclosed "green
FAKRA to RCA jack" adapter (see picture).
8. Refit the head unit.
9. Activating the TV input: Press "AV". After the first system start up, the DVB-T mode is active.
For use of the control function, the station buttons 0-9 of the PCM first have to be assigned with channels. On
each station button a channel has to be stored as follows: press the right rotary knob for getting into the TV
menu. Select "Channel entry" and tune to Ch "1". Press the right rotary knob for confirmation and make a long
press on the station button "1" afterwards, to store the channel there. A sound can be heard when the channel is
stored. Make the same steps again with channel 2 on station button 2 ... channel 10 with station button 10.

Control of the AIV DVB-T-Tuner 190860 with PORSCHE PCM2.1

Operation:
Buttons 2, 4, 5, 6, 8 on the numerical pad yielding "crosshairs" for navigation within the menu!
1. Program information (station name, title and length of current broadcast). („EPG").
2. Menu one step up. („CH+")
3. Displays antenna signal strength („OOOOO%")
4. Menu one step left. („VOL-")
5. „OK".
6. Menu one step right. („VOL+")
7. Menu.
8. Menu one step down. ("CH-")
9. Menu one step back (Exit button from remote control).
10. Source (AV1, AV2, TV). („FUNC")
11. Channel down (last preset). („CH-") This feature can also be controlled with the steering wheel controls. *
12. Channel up (next preset). („CH+") This feature can also be controlled with the steering wheel controls. *
* Due to the PCMs' technical design, the functions for channel+/- are interchanged. Consequently the button for
channel + is "<" and channel – is ">".
A·I·V GmbH + Co. KG ● Tatschenweg 1 ● 74078 Heilbronn
27
E
N
G
L
I
S
H