Control Of The Aiv Dvb-T 190860 And Aiv Dvd 190861 With Bmw; Installation Mercedes Comand Aps Ntg2 - IMU 670848 Bedienungsanleitung

22
7. Now connect the enclosed RCA adapter (video signal) into the MOST plug
chamber A (see Picture 8) as follows: BMW E90, E60, E63: Pin2= Video ground /
shield, Pin4= video signal.
8. Connect RCA jacks - A: audio left (black), B: audio right (red), with the audio
output of the video source. The yelllow RCA jack (C) is only used when the video
source delivers a NTSC signal. Information on connection can also be found on
page 21. Connection with the video source should only be done with a high quality
RCA video cable, otherwise the picture quality could be bad, caused by a weak video signal. The video
E E
output signal (CVBS) is fed into the head unit directly by using the enclosed "RCA jack with 2 MQS terminal"
N N adapter (see point 7).
G G
9. Refit the navigation unit.
L L
I I
10. Activating the TV input: Select "TV" in the iDrive menu.
S S
H H

Control of the AIV DVB-T 190860 and AIV DVD 190861 with BMW

Operation:
When tapping the iDrive while being in the TV mode, a menu is fading in. This menu shows a complete
list of all possible control functions. The list which is being shown at first is always the list with control
functions for a TV tuner. Each control function which is listed matches the respective function of the
corresponding remote control. While turning the iDrive to the right or left, the desired control function can
be selected and activated when pressed down. With the icon "Settings" (car specific) adjustments to
brightness, contrast etc. can be done. The last function on the list is the icon "[ DVD ]". When selected,
a new function list is being generated for a DVD player. This enables to control the AIV DVD
player 190861 as well. To connect both units parallel please use additional the item 670864.
ATTENTION:
The correct AV input should be selected at the TV tuner, before switching to the DVD control list via
the "[ DVD ]" icon. Otherwise it's possible to activate any function of the DVD player without seeing the
DVD screen.

Installation MERCEDES COMAND APS NTG2

1. Switch off ignition and remove the key.
2. Remove and disconnect the head unit.
3. Release the fibre optic cables from the main MOST connector of the head unit (pic.1), and pull out thesmall
connector (pic.2). Afterwards push out the blue locking (pic.3), and then pull out the fibre optic from the
output (!) (see the right arrow on pic.4), while carefully bending the clip with a small screw driver. Then put
this fibre optic into the connector from the enclosed fibre optic cable kit (pic.5, this connector must lead to
the input of IMU 670848 on its' other end via the fibre optic!!)The remaining fibre optic without connector
now has to be plugged into the open slot (pic.6). With that, the fibre optic ring must be closed entirely again!
A·I·V GmbH + Co. KG ● Tatschenweg 1 ● 74078 Heilbronn