Lieferumfang - 1 St. Bedienungsanleitung - 1 St. Kabelbaum - 1 St. Multimedia Interface - 1 St. Cinch FAKRA Adapterkabel für Videosignal - 1 St. Lichtleiteranschlusskabel - 1 St. Cinch Anschlusskabel für Videosignal - 1 St. MOST Gehäuse - 4 St. Abzweigverbinder, rot Allgemeine Sicherheitshinweise WARNUNG Die Installation darf nur durch geschultes Fachpersonal durchgeführt werden.
Schalten Sie bei Rauch-, Geräusch- und/oder Geruchsentwicklung das Gerät sofort ab und trennen Sie es sofort von der Spannungsversorgung. Benutzen Sie das Gerät nicht weiter! Setzen Sie das Gerät keiner starken Sonnenbestrahlung oder anderen starken Hitzeeinwirkungen aus! Montieren Sie das Gerät nie in der Nähe von oder gar über Radiatoren, Warmluftschläuchen oder anderen Wärmequellen.
Installation Das Interface kann an folgenden Navigationssystemen angeschlossen werden: Fahrzeug Head Unit BMW: Navigationssystem Professional 3er E90, 5er E60, 6er E63 bis 06/07 MERCEDES: A-W169, B-W245 COMAND APS C-W203 & CLK-W209 04/04~ M-W164, GL-X164 NTG2 R-W251 Vito MERCEDES: COMAND APS E-W211 NTG1* CLS-W219...
Seite 6
Mercedes-Benz Partner über die Star Diagnose der MOST Ring nach außen hin geöffnet werden. Andernfalls kann das IMU 670848 Interface vom COMAND nicht erkannt werden. Dazu muss in der Diagnose als Komponente 1 das AGW codiert sein, danach als Komponente 2 z.B. Telefon, CD-Wechsler…, als letzte Komponente dann COMAND.
(Bild 6). Der Lichtleiterring muss nun wieder vollständig geschlossen sein! 4. Den kleinen Lichtleiter Stecker wieder in den MOST Hautpanschluss Stecker stecken. 5. Den jetzt noch offenen Lichtleiterstecker (Bild 7) mit dem Lichtleiteranschluss IMU 670848 verbinden (siehe Seite 6, Bild 2, Anschluss B).
Lichtleiterkabelsatzes gesteckt (Bild 5, das Verbindungsstück muss zur anderen Seite über den Lichtleiter zum Eingang am IMU 670848 führen!!). Der andere Lichtleiter des Kabelsatzes ohne Verbinder wird nun in den jetzt freien Steckplatz gesteckt (Bild 6). Der Lichtleiterring muss nun wieder vollständig geschlossen sein! A·I·V GmbH + Co.
Seite 9
4. Den kleinen Lichtleiter Stecker wieder in den MOST Hautpanschluss Stecker stecken. 5. Den jetzt noch offenen Lichtleiterstecker (Bild 7) mit dem Lichtleiteranschluss am IMU 670848 verbinden (siehe Seite 6, Bild 2, Anschluss B). 6. Jetzt die schwarze Leitung vom Kabelsatz von Anschluss A (Seite 6, Bild 2) an Masse, die rote Leitung an „Dauer-“...
4. Den kleinen Lichtleiter Stecker wieder in den Hautpanschluss Stecker stecken. 5. Den jetzt noch offenen Lichtleiterstecker (Bild 7) mit dem Lichtleiteranschluss am IMU 670848 verbinden (siehe Seite 6, Bild 2, Anschluss B). 6. Jetzt die schwarze Leitung vom Kabelsatz von Anschluss A (Seite 6, Bild 2) an Masse, die rote Leitung an „Dauer-“...
9. Head Unit wieder einbauen. 10. Aktivierung des TV Eingangs: Taste “VIDEO” drücken, und danach im Menü mit dem Soft key „TV“ aktivieren. „AV1“ und „AV2“ können ebenfalls angewählt und benutzt werden, allerdings ist bei dieser Funktion die Benutzung der Tasten zur Steuerung nicht möglich! Steuerung des AIV DVB-T Tuners 190860 mit Mercedes Funktion: Die Zifferntasten 2, 4, 5, 6, 8 direkt am COMAND ergeben ein „Fadenkreuz“...
4. Den kleinen Lichtleiter Stecker wieder in den Hautpanschluss Stecker stecken. 5. Den jetzt noch offenen Lichtleiterstecker (Bild 7) mit dem Lichtleiteranschluss am IMU 670848 verbinden (siehe Seite 6, Bild 2, Anschluss B). 6. Jetzt die schwarze Leitung vom Kabelsatz von Anschluss A (Seite 6, Bild 2) an Masse, die rote Leitung an „Dauer-“...
NTSC Signal benötigt. Anschlusshinweise dazu finden Sie ebenfalls auf Seite 6. Die Videoverbindung darf nur mit einem videotauglichen Cinch Kabel hergestellt werden, da es sonst zu Verlusten in der Bildqualität kommt. Das Video Ausgangssignal (FBAS) wird mittels beiliegendem Adapter (grüner FAKRA Stecker auf Cinch Buchse) direkt in die Head Unit eingespeist (siehe Bild).
Technische Daten Softwarestand: SW 1.2.1 Spannungsversorgung: 12 V DC Spannungs-Arbeitsbereich: 10,0 – 14,6 V DC Ruhestrom: 20 mA Leistungsaufnahme max.: 0,3 W Temperaturbereich: -40 - +85 °C Gewicht: 0,168 kg Abmessungen: 106 x 70 x 32 mm Das Gerät ist für den Automotiven Bereich gedacht und hat daher eine Lebensdauer von maximal 10 Jahren. A·I·V GmbH + Co.
Table of content Table of content..............................16 General advice ..............................16 Scope of delivery..............................17 General safety instructions............................ 17 References of legal regulations for operation ....................... 18 Installation ................................19 Connector assignment ............................21 Installation BMW 3-series E90, 5-series E60, 6-series E63 ................. 21 Control of the AIV DVB-T 190860 and AIV DVD 190861 with BMW ..............
Scope of delivery - 1 pc. instruction manual - 1 pc cable kit - 1 pc. multimedia interface - 1 pc cinch FAKRA cable for video - 1 pc. fibre optic cable - 1 pc cinch cable for video - 1 pc. MOST house - 4 pc.
If smoking, abnormal sound or peculiar smell happens, disconnect the power source. Stop using this unit. Protect the unit against any kind of heat. Never mount it close to heat sources. This product should never be placed near or over a radiator or under the sun. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided.
Installation The interface can be used with the following navigation systems: Head Unit BMW: Navigation system Professional 3er E90, 5er E60, 6er E63 up to 06/07 MERCEDES: A-W169, B-W245 C-W203 & CLK-W209 04/04~ COMAND APS M-W164, GL-X164 NTG2 R-W251 Vito MERCEDES: COMAND APS E-W211...
Seite 20
For this reason There should not be programmed a TV tuner, as this causes the system to put out the error code “TV not found”. For a proper working of the interface IMU 670848, it is sufficient to let the COMAND just open its’...
(pic.5, this connector must lead to the input of IMU 670848 on its’ other end via the fibre optic!!) The remaining fibre optic without connector now has to be plugged into the open slot (pic.6). With that, the fibre optic ring must be closed entirely again! 4.
(pic.5, this connector must lead to the input of IMU 670848 on its’ other end via the fibre optic!!)The remaining fibre optic without connector now has to be plugged into the open slot (pic.6). With that, the fibre optic ring must be closed entirely again!
Seite 23
8. If it is intended to use the AIV DVB-T 190860 or the AIV DVD 190861, the control cable kit 670846, 670847 or 670864 has to be connected with its’ counterpart at the video source and the IMU 670848. 9. Refit the head unit.
(pic.5, this connector must lead to the input of IMU 670848 on its’ other end via the fibre optic!!) The remaining fibre optic without connector now has to be plugged into the open slot (pic.6). With that, the fibre optic ring must be closed entirely again! 4.
Control of the AIV DVB-T-Tuner 190860 with MERCEDES Operation: Buttons 2, 4, 5, 6, 8 on the numerical pad yielding “crosshairs” for navigation within the menu! 1. Program information (station name, title and length of current broadcast). („EPG“). 2. Menu one step up. („CH+“) 3.
(pic.5, this connector must lead to the input of IMU 670848 on its’ other end via the fibre optic!!) The remaining fibre optic without connector now has to be plugged into the open slot (pic.6). With that, the fibre optic ring must be closed entirely again! 4.
7. Connect RCA jacks - A: audio left (black), B: audio right (red), with the audio output of the video source. The yelllow RCA jack (C) is only used when the video source delivers a NTSC signal. Information on connection can also be found on page 21.
Technical data Software release: SW 1.2.1 Power supply: 12 V DC Working Voltage: 10,0 – 14,6 V DC Quiescent current: 20 mA Power consumption: 2 W Temperature range: -40 - +85 °C Weight: 0,168 kg Dimensions: 106 x 70 x 32 mm This unit is only for automotive use and has therefore a lifetime of max.