IMU 670848 Bedienungsanleitung Seite 23

4. Re-connect the small fibre optics connector with the MOST main connector.
5. Connect the remaining fibre optics connector (pic.7) with the counterpart
at the IMU 670848.
6. Now connect the black wire from the harness with ground,
and the red one with "permanent" +12V.
7. Connect RCA jacks - A: audio left (black), B: audio right (red),
with the audio output of the video source. The yelllow
RCA jack (C) is only used when the video source delivers
a NTSC signal. Information on connection can also be found
on page 21. Connection with the video source should only
be done with a high quality RCA video cable, otherwise the
picture quality could be bad, caused by a weak video signal.
The video output signal (CVBS) is fed into the head unit
directly by using the enclosed "green FAKRA to RCA jack"
adapter (see picture).
8. If it is intended to use the AIV DVB-T 190860 or the AIV DVD 190861, the control cable kit 670846,
670847 or 670864 has to be connected with its' counterpart at the video source and the IMU 670848.
9. Refit the head unit.
10. Activating the TV input: Press "VIDEO" and select "TV" with the soft key. "AV1" and "AV2" can be
selected and used as well, but use of the buttons for controlling the connected source is not possible
in this mode!
A·I·V GmbH + Co. KG ● Tatschenweg 1 ● 74078 Heilbronn
23
E
N
G
L
I
S
H