6.2.3 Configuring Newly Taught-In Devices - HomeMatic HM-LC-Dim1T-FM Installationsanleitung

ton input (see section „5 Installation" on page 33).
• Press and hold down the pushbutton for about 4
seconds within the first 5 minutes of switching on
the mains voltage.
The device LED will flash continuously to indicate
•
that teach-in mode is active.
• After a short time, the newly taught-in device ap-
pears in the inbox of your software interface. The
button "Inbox (x new devices)" indicates how many
new devices have been taught-in successfully.
• If required, you can teach-in additional devices
by repeating the steps described above for each
device.
Now configure the newly taught-in devices in the
•
inbox as described in the next section ("Configuri-
ng newly taught-in devices").

6.2.3 Configuring newly taught-in devices

Once you have taught-in your device to the Home-
matic Central Control Unit, it is moved to the inbox.
Here, you must configure the device and its associated
channels in order to make them available for operat-
ing and configuration tasks. Give the device a name
and assign it to a room. You can also make individual
parameter settings.
Now you can use the "WebUI" user interface to control
your device, configure it, link it directly to other de-
Start-up
41