Luda tractorCam Bedienungsanleitung Seite 36

• The signal is not good enough.
• The camera isn't paired with the
monitor. (The pair indicator isn't lit up)
• The camera isn't set to ON in the
monitor.
Bad reception/low frame rate
Possible error
• The picture updates slowly due to bad
reception.
Black & white picture
Possible error
• Pale colours or black & white picture.
The trigger function isn't working
Possible error
• The camera isn't paired with the monitor
on Channel 1.
• The trigger cable isn't supplied with
power.
36
• Draw power from somewhere else or
purchase our Flexi Pack accessory.
• Change antenna or move the camera,
monitor or the antenna with cable to
another position where there are less
objects for the signal to pass through.
• Pair the camera with the monitor as
described in chapter 9.
• In the monitor menu, set the camera
to ON. (Or Mirror if you would like a
mirrored image.) See chapter 4.
Action
• Change antenna or move the camera,
monitor or the antenna with cable to
another position where there are less
objects for the signal to pass through.
Action
• In dark conditions the IR-LEDs will
automatically switch on resulting in pale
colours. In pitch-black surroundings the
picture will become black & white.
Action
• Pair the camera with the monitor on
Channel 1, see Chapter 9.
• Check the connection of the trigger cable.
If possible, measure the power supply.