Transport And Storage; Safety Measures - Unitest 3000 Bedienungsanleitung

Transport and Storage

The scope of supply comprises of:
1 UNITEST Cable Length Meter 3000
2 Test Leads with Kelvin Clamps
1 Compensation Ring
1 Battery 9V, IEC 6LR61
2 Troubleshooting Summary Cards
1 Instruction Manual
1 Copper Nail (10 pieces)
Accessories:
Windows Software UNITEST "Report Studio"
Order No.: 1207
2.0 Transport and Storage
Please keep the original packaging for later trans-
port, e.g. for calibration. Any transport damage due
to faulty packaging will be excluded from warranty
claims.
In order to avoid instrument damage, it is advised
to remove accumulators when not using the instru-
ment over a certain time period. However, should
the instrument be contaminated by leaking battery
cells, you are kindly requested to return it to the fac-
tory for cleaning and inspection.
Instruments must be stored in dry and closed areas.
In the case of an instrument being transported in ex-
treme temperatures, a recovery time of minimum 2
hours is required prior to instrument operation.

3.0 Safety Measures

The UNITEST Cable Length Meters have been built
and tested in compliance with the valid Regulations
and have left the company in safe and perfect con-
dition. To maintain this condition, the user must
comply with the safety references contained in this
instruction manual.
Never apply voltage to any of the instrument
measurement ranges. Always verify that the
circuits are not live using a dual-pole volt-
age tester (e.g. UNITEST 2000 alpha)!
20
Prior to any operation, ensure that connecting
leads and instrument are in perfect condition.
The respective accident prevention regulations
established by the professional association for
electrical systems and equipment must be
strictly met at all times.
The instrument may only be used within the op-
erating ranges as specified in the technical data
section.
Prior to opening, the instrument has to be
switched off and disconnected from any cir-
cuit.
Avoid any heating up of the instrument by di-
rect sunlight to ensure perfect functioning and
long instrument life.
Appropriate Usage
The instrument may only be used under those
conditions and for those purposes for which it
was built. For this reason, in particular the safe-
ty references,as well as the technical data in-
cluding environmental conditions and the
usage in dry environments must be followed at
all times.
The operational safety of the instrument is noi
longer guaranteedafter unauthorised modifi-
cations or changes.
The instrument may only be opened by an au-
thorised service technician, e.g. for fuse re-
placement.