Introduction/Scope Of Supply - Unitest 3000 Bedienungsanleitung

References marked on instrument or in
instruction manual:
Warning of a potential danger, comply with in-
struction manual.
Reference. Please use utmost attention.
Caution! Dangerous voltage. Danger of electri-
cal shock.
Continuous double or reinforced insulation
complies with category II.
Conformity symbol, the instrument complies
with the valid directives. It complies with the
EMC Directive (89/336/EEC), Standards EN
50081-1and EN 50082-1 are fulfilled. It also
complies with the Low Voltage Directive
(73/23/EEC), Standard EN 61010-1 is fulfilled.
The instruction manual contains information
and references, necessary for safe opera-
tion and maintenance of the instrument.
Prior to using the instrument (commissioning
/ assembly) the user is kindly requested to
thoroughly read the instruction manual and
comply with it in all sections.
Failure to read the instruction manual or to
comply with the warnings and references
contained herein can result in serious bodi-
ly injury or instrument damage.
1.0 Introduction / Scope of Supply
You have acquired a high standard measurement in-
strument distributed by the company Ch. BEHA
GmbH which is able to perform reproducible mea-
surements over a very long time period. The com-
pany Ch. BEHA GmbH is a member of the world-
wide operating BEHA group. The head office of the
BEHA group is located in Glottertal/Schwarzwald,
together with the technological centre. The BEHA
group is a leading enterprise for test and measure-
ment instruments.
Introduction / Scope of Supply
The UNITEST Cable Length Meters are universally
usable cable length measurement instruments.
They have been built in compliance with the most
recent prescriptions and guarantee safe and reliable
measurements. All UNITEST Cable Length Meters
are a valuable support for trade and industry for tally
measurements, inventories and residual length
measurements.
The instruments has the following
characteristics:
• Cable Length Meter for easy and time efficient
measurement of cable length in trade and indus-
try, utility companies, and specialist electronic
stores
• 56 fixed, pre-programmed measurement ranges,
representing the most common cable cross sec-
tions
• 84 variable measurement ranges, individually
programmable by the user to measure customer
specific conductor and cable types
• Internal data memory to save 500 measurements
for inventories, tally measurements, cable return
measurements, etc.
• RS232 interface for transfer and further PC pro-
cessing of measurement data
• Cumulative data memory for measurement and
adding of several cable rings of the same type of
conductor, saving time and money
• Measurable cable cross sections between 0,05
and 500 mm2
• Precise measurement using the four-pole mea-
surement procedure (Kelvin procedure), requiring
both cable ends
• Additional resistance measurement up to 2000
Ohm and acoustic continuity test
• Display light for better visibility while working in
badly illuminated environments, such as storage
areas
• External, internal, or manual temperature com-
pensation for more precise measurement results
• Automatic power off
19