AIPTEK BIZCAM Trio Handbuch Seite 9

Start Aiptek BizCam Manager
Stored pictures may be uploaded to a PC at any time whether or not the
camera is full. Plugging the USB connector into the camera will cause it to
reset. A double beep will sound, but all stored pictures will remain. When the
USB connector is unplugged the camera will switch off. When connected to
the PC the camera may be used as a normal PC camera.
To start using the BizCam Manager, simply click on the "Start" menu and
go up to "Programs" Then go to the folder named "BizCam" and select it.
This is the program where you can begin to use your camera.
Connect the smaller end of the
USB connector to the side of the
camera.
Plug the other end of
the USB connector
into an available USB
port on your computer.
@ n I P C o m p a n y
Note:When plugged into
a USB port the camera
gets its power from the
PC. The camera may be
used like this without
any batteries. However,
all pictures will be lost
when the USB connector
is unplugged.