Audio Settings - Peaq PBR510 Bedienungsanleitung

ENGLISH

Audio settings

To access the audio settings press AUDIO
SETUP on the remote control. Audio setup
settings are shown on the panel of the
appliance. Select the desired setting with the
and buttons. Press ENTER to confirm.
The follwing settings can be made:
LEVEL: The volume for each speaker can
be adjusted individually. Select the desired
speaker with the and
C Center
FL Front left
FR Front right
SW Subwoofer
SL Rear left
SR Rear right
The volume can be adjusted with the
buttons in a range from -10 to +10. Press
ENTER to confirm.
HDMI AUDIO OUT: The audio output for
the HDMI output can be set ON or OFF.
With this setting you can select if sound is
transfered via the HDMI connection.
TESTTONE: A test tone (white noise) can be
activated in order to level the volume of the
speakers at the listening position.
LIPSYNC: To syncronize sound and picture
the lipsync function can be used. The sound
can be delayed from 0 to 120 ms by pressing
the and buttons.
SURROUND: The surround mode can be
set by pressing the and
5.1 CH 5.1 channel surround sound
DPLII Dolby ProLogic 2
®
STEREO Stereo playback
TONE: Bass and treble can be adjusted
individually. The function can be selected
with the and buttons. Adjust it with the
and buttons in a range from -6 to +6.
DISTANCE: To adjust run time differences
caused by different distances between the
speakers and the listening position, the
distance can be set individually. Select the
desired speaker with the
C
FL
FR
SW
buttons: SL
SR
The distance can be adjusted with the
buttons in a range from 0 to 400 cm in 20
cm increments. Press ENTER to confirm.
and
buttons:
and
Center
Front left
Front right
Subwoofer
Rear left
Rear right
56
buttons:
and