Instruction Manual - Clatronic mr 670 Bedienungsanleitung

General safety instructions
To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug so-
cket. Pay attention that the specifi ed voltage corresponds
to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries in
the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should the
device become damaged, in particular the mains supply
cable, do not operate the device any longer, but rather
have it repaired by an expert. Check the mains supply
cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove
the plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompanying
documentation.
Devices bearing this symbol work with a
„class 1 laser" for tracing the CD. The built-in
safety switches should prevent the user being
exposed to dangerous laser light, which is
invisible to the human eye, when the CD compartment is
opened.
Under no circumstances should these safety switches be
bypassed or manipulated, as this could result in a danger
of exposure to the laser light.
18
05-MR 4101 AEG 18
Overview of the Components
1 Function selector switch
2 Station scale
3 TUNING control
4 VOLUME
5 Loudspeakers
6 Aerial
Initial Use of the Radio Recorder/
Introduction
• Please read the operating instructions carefully before
using the radio recorder for the fi rst time!
• Select a suitable location for the radio recorder, such
as a dry, fl at, non-slip surface on which it is easy to
operate the machine.
• Ensure that the radio recorder is suffi ciently ventila-
ted!
Power supply
Insert the plug into a properly installed 230 V, 50 Hz
power socket. Ensure that the voltage is the same as that
indicated on the model identifi cation plate.
Listening to the Radio
1. Turn the function selector switch to the FM or AM po-
sition, depending on which frequency band you would
like to listen to.
The POWER lamp shows that the device is on.
UKW = FM, Medium Wave = AM.
2. Tune into the desired station using the TUNING regu-
lator.
3. For VHF/FM mode pull out the telescopic antenna
and turn it to improve reception. Proceed in a similar
manner if you wish to receive MW/AM stations.
Volume
The desired volume can be sent using the VOLUME
regulator.
Switch-off
The radio is switched off when the function selector
switch is turned to the "OFF" position. Unplug the device.
Cleaning and care
• Before cleaning remove the mains lead from the
socket.
• Clean the housing with a soft, dry cloth without additi-
ves.
This device has been tested according to all relevant cur-
rent CE guidelines, such as electromagnetic compatibility
and low voltage directives, and has been constructed in
accordance with the latest safety regulations.
Subject to technical changes without prior notice!
30.03.2005, 15:27:00 Uhr