Start-Up Of The Device/Introduction; Cleaning And Maintenance - AEG MR 4129 Bedienungsanleitung

10 AC~ Mains connection
11 Battery compartment

Start-up of the device/introduction

• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
Power Supply (Power cable)
• Connect the power cable supplied (see battery compart-
ment if necessary (11)) to a properly installed safety power
socket and the mains connector AC~ (10) on the back of
the machine.
• Ensure that the voltage is the same as that indicated on
the model identification plate.
Power supply (Batteries)
(not supplied)
• Open the lid of the battery compartment (11) on the bot-
tom.
• Insert 6 batteries of type AA/R6 1.5 V. Please ensure that
the polarity is correct (see the floor of the battery com-
partment)!
• If the device is not used for a long period of time, remove
the batteries to avoid the spilling of battery acid.
• Then close the battery lid.
WARNING:
The batteries shall not be exposed to excessive heat such
as sunshine, fire or the like. Danger of explosion!
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
NOTE:
When a mains cable is connected the batteries are auto-
matically switched off.
Headphone Socket
Please use headphones with a 3.5 mm stereo jack plug; these
should be inserted into the PHONES socket. The loudspeak-
er is switched off.
Volume
The desired volume can be sent using the VOLUME regula-
tor (3).
Switching On/Off
• Turn the device on by moving the function selector switch
(5) to the FM position. The POWER indicator light goes
on.
• The machine is switched off when the function selector
switch (5) is turned to the OFF position. The POWER
indicator light turns off. Unplug the device.
Listening to the Radio
1. Turn the function selector switch (5) to the FM position.
2. Tune in the desired station with the station adjustment
knob TUNING (2).
3. For VHF/FM mode pull out the telescopic antenna (7)
and turn it to improve reception.
AUX IN socket
To connect analogue replay devices. Through this socket you
can also listen to the sound of other playback devices such as
MP3 players, CD players etc. through the loudspeaker.
1. Turn the function selector switch (5) to FM.
2. Please connect the external device with a 3.5 mm stereo
jack plug to the AUX socket (8). The device switches
automatically to AUX IN operation. The radio sound is
switched off.
3. Through the loudspeaker you will hear the sound being
played back from the external device. With the VOLUME
control (3) you can change the volume.
4. For the remaining procedure please see the operating
instructions of the external sound source.
NOTE:
Adjust the volume of the external device to a comfortable
level.

Cleaning and Maintenance

CAUTION:
• Do not use abrasive detergents! These can damage
the casing!
• Make sure that no humidity or water penetrates in the
device!
• Always remove the mains plug before cleaning the
machine.
• Clean the device only with a soft, dry cloth.
• Any marks on the surface can be wiped off with a slightly
damp cloth without any additives.
• Dry well with a dry, soft cloth!
English
21