Transmission Mode Setting; Disconnecting Bluetooth - Panasonic SC-NT10 Bedienungsanleitung

Selecting Transmission mode setting
You can change the transmission speed to prioritise sound quality or connectivity.
• The default setting is "Sound Quality Priority MODE". When the sound is interrupted, select
"Connectivity Priority MODE".
1 Set either of the following modes.
∫ Sound Quality Priority MODE:
While pressing and holding [
until the Bluetooth
indicator (orange) blink once.
∫ Connectivity Priority MODE:
While pressing and holding [BOOST], press and hold
[VOL -] until the Bluetooth
Mode indicator (orange) blink once.
2 Press [Í/I] to turn this unit off, and press [Í/I] again to turn on.
• The Bluetooth
(blue) lights up.

Disconnecting Bluetooth

• Turn off this unit or the device.
• Stop / disable the Bluetooth
• (For NFC-compatible devices only)
Touch and hold your device to NFC touch area of this unit again.
Note
• This unit can only be connected to one device at a time.
• This unit can register up to 8 devices. If a 9th device is paired, the device that has not been
used for the longest time will be replaced.
• Even when this unit is turned off, if this unit is connected to the PC that is powered on with an
USB cable and this unit is selected on the device that is paired with this unit, power of this unit
will be turned on and connected via Bluetooth
• If the image and sound are out of sync during playback, restart the playback app you are
using. If the problem persists, connect the Bluetooth
• The One-Touch Connection may not work properly depending on the type of device being
used.
®
indicator (blue) and the Boost Mode
®
connection is automatically established, and the Bluetooth
®
®
transmission of the device.
], press and hold [VOL -]
®
indicator (blue) and the Boost
®
automatically.
®
device and this unit with an audio cable.
®
indicator
9
9