Herunterladen Inhalt Inhalt Diese Seite drucken

Special Safety Precautions For This Device - AEG BSS 4805 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Remote Control
1 REPEAT (repeat) button
2
MUTE button
3 Number buttons
4 10+ button
5 "F" button
6
CH+/ CH- buttons (next/previous track / select
preset radio stations)
7
button (Stop)
8 VOL+/VOL- buttons (volume)
9 TONE button
10 SEARCH button
11 MO/ST button (Mono/Stereo)
12 SAVE
button
13
(play/pause) button
14
TU+/ TU- buttons (scan forward/back)
15 FM button (radio)
16 AUDIO button
17 BLUETOOTH button
18 USB button
19
STANDBY button (On/Off)
20 RANDOM button (random playback)

Special Safety Precautions for this device

WARNING:
Avoid hearing loss due to extreme volume.
CAUTION:
• Do not subject the speakers to extreme heat, cold or
humidity.
• Do not operate the device on maximum volume. This
can cause damage.
• Do not touch the speaker membranes with fingers or
objects. This will cause damage to the membranes.
First Use of the Device/Introduction
NOTE:
Some buttons can be found both on the device and on the
remote control. Identical buttons perform the same func-
tion.
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Mount Pedestal
• Carefully place the left hand side of the speaker box onto
a table.
NOTE:
Place a blanket under the speaker to avoid scratching
the surface.
• Mount the bottom plate with four screws at the bottom
of the speaker box.
• Now stand the speaker box on the floor again.
Power supply
• Connect the mains cable to the connector jack socket on
the back of the device.
• Insert the grid plug into a properly installed three prong
socket with 230 V, 50 Hz.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Insert/Replace Battery in Remote Control
NOTE:
The lithium cell in the battery compartment of the remote
control may have been safeguarded for transport with a
piece of foil. This extends the life of the battery. Please
remove this foil before the first use to make the remote
control ready for operation.
• Open the battery compartment on the underside of the
remote.
• Replace the cell by a battery of the same type (CR 2025).
Check that the polarity is correct (see battery compart-
ment).
• Close the battery compartment.
If the remote is not in use for a lengthy period of time, please
remove the battery to prevent the battery acid from "leaking".
WARNING:
• Do not expose the batteries to intense heat, such as
sunlight, fire or similar. Danger of explosion!
• Keep batteries out of the reach of children. They are
not toys.
• Do not force batteries open.
• Avoid contact with metallic objects. (Rings, nails, screws
etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
• When transporting the batteries, cover the terminals for
your safety with an adhesive strip.
• If a battery leaks, do not rub the fluid into the eyes or
the skin. If acid comes into contact with the eyes, rinse
with purified water and seek medical advice if symp-
toms persist.
English
41

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis