ION SOUND SPLASH Kurzanleitung Seite 3

FEATURES
1. Hook - Use this to hang SOUND SPLASH from a shower
head or shower stall.
2. Speaker - Listen to music or a phone call from this full range
speaker.
3. Power On/Off - Press and hold this button for 4-5 seconds to
power SOUND SPLASH on/off.
4. Bluetooth - Press and hold this button for 2 seconds to
activate pairing mode on SOUND SPLASH. Press and hold it
again for 2 seconds to unpair your device. If you do not
unpair your device, SOUND SPLASH will "remember" your
device even if it is powered off then on again.
5. Call Receive/Call End - When a paired device receives a
phone call, press this button to answer the call; press it again
to disconnect the call.
6. Volume Down - Turns down the volume for a paired
Bluetooth device.
7. Play/Pause - Press this button to start/pause music playback
on a paired music device.
8. Volume Up - Turns up the volume for a paired Bluetooth
device.
9. Microphone - Talk into this after receiving a call.
10. Micro USB Port - Use the included USB cable to connect
this port to a USB port on your computer or phone
charger to recharge SOUND SPLASH's battery.
11. Suction Cups - Attach these to the back of SOUND
SPLASH and then to the shower wall.
Note: Attach the suction cups to a solid, non-porous surface
for an airtight seal. Glass, metal, smooth tile and polished
wood are surfaces where suction cups stick best.
Note: For best results, ensure that the shower wall is
thoroughly clean and dry before attaching suction cups.
1
2
3 4 5
6 7 8
6 6
9
3
1
2
4 5
3
6 7 8
9
10 10