Olympus CAMEDIA E-20 Anleitung Seite 10

Date or Time
You can use settings in the setup/connection
mode to set the date, time and date format.
When you take a picture, the current date and
time are recorded with the image. This
recorded date or time can be stamped on the
printed image if you use "select date or time" in
the DPOF print stamping mode for printing.
Processing and handling images with
CAMEDIA Master ensures that this date and
time information is preserved, even after the
images are transferred to a computer.
Otherwise, this date and time information may
be lost with other graphics software
applications.
10
After you set up date or time stamping, the
setting applies to all images selected for
printing. Insert the memory card that contains
the pictures that you want to select for date or
time stamp printing. Check the control panel
display and make sure that the mark for the
source card, SmartMedia
Microdrive is displayed. If the correct mark
is not displayed, press and hold the SM/CF
memory card button, and then turn the main
dial or sub dial until it is displayed. Set the
mode dial to the print reserve mark
the menu button to open the menu in the
monitor. Press or
highlight to the date/stamp mark
to move the green highlight to the right, and
then press again to move the green highlight to
DATE or TIME, or if you want to cancel the date
or time setting move the green highlight to OFF.
Press the button to select the setting. Press
the button again to close the menu.
or CompactFlash/
. Press
to move the green
. Press