Peaq PPA300 Bedienungsanleitung Seite 31

ENGLISH
Operation
START
Press on the device or on the remote con-
trol to switch the appliance on. While the ap-
pliance is on, a white LED is on.
STANDBY
To turn the unit back into standby mode,
press on the device or on the remote con-
trol. While the appliance is in standby, a red
LED is on.
VOLUME
Press + on the panel or VOL+ on the remote
control to increase volume.
Press - on the panel or VOL- on the remote
control to decrease volume.
PREVIOUS
NEXT
During playback, press
track. After three seconds, to skip to previ-
ous track, press twice fast. If pressed
once, current track will be played from the
beginning.
PLAY / PAUSE
In stop mode, press
back. To pause the playback temporarily,
press
To resume, press
3D EMOTION
Press 3D on the remote control to switch the
3D Emotion sound ON or OFF.
LINE IN
Use a 3.5 mm audio cable to connect exter-
nal audio sources via the LINE IN jack.
NOTE: The source of the docking station
is the first priority playback source. Please
remove the iPhone/iPod from the docking
station in order to listen through LINE IN.
to skip to the next
once to start play-
once more; sound will be muted.
again.
30