Battery Status; Battery Replacement Instructions - Gear4 Explorer-SP Benutzerhandbuch

N.B. Explorer-SP will automatically select iPod
mode and override the line-in.
REPEaT / SHUFFLE PLay:
To repeat the current track – press
■
remote control once.
To repeat the whole album – press
■
remote control twice. Press again to cancel.
To shuffle songs – press
■
control. Press again to cancel.
3D sound:
Explorer-SP has a 3D button for increased width
and depth to your music.
To activate 3D sound press the 3D button on
■
either your speaker or remote control.
For use with other
music players:
Plug one end of a 3.5mm audio cable (not
■
included) into your MP3 or MP4 player and
connect the other end into the AUX line-in
port at the back of the speaker.
Use your device to control the music.
■
N.B. Your iPod / iPhone must be removed from
the dock.
� on the
� on the
� on the remote

Battery status:

The three green LEDs on the top of the speaker
will display the charging status / remaining
power of the battery:
– 0-10% Charge: 1 Flashing LED
– 10-40% Charge: 1 Solid Green LED
– 40-70% Charge: 2 Solid Green LEDs
– 70-100% Charge: 3 Solid Green LEDs
Battery replacement
instructions:
It is recommended that you charge the
■
Explorer-SP for 8 hours before first use.
A properly maintained battery will retain up to
■
80% of its original capacity at 300 full charge
and discharge cycles. You may choose to
replace your battery when it no longer holds
sufficient charge to meet your needs.
New batteries may be purchased from
www.gear4.com/store
Use a screwdriver to unscrew the
■
battery compartment.
Remove the cover from the back (gently tap
■
the case until compartment pops up).
Disconnect the old battery and connect up
■
the new Lithium-ion battery.
User Manual | Explorer-SP | GEAR4 8