Nikon Nuvis S 2000 Bedienungsanleitung Seite 33

Problem
No indicators appear on
the LCD panel when the
slide cover is opened.
The shutter cannot be
released even if the
shutter release button on
the remote control unit
is pressed.
A characteristic of electronic camera
In rare cases, when strong static electricity or the like is applied to the camera, the camera may not work properly.
If this happens, remove the battery. Please note that the date and time must be reset when the battery is replaced,
because settings are erased when the battery is removed. (
•The battery was not properly loaded in the battery chamber. Make sure to orient the positive
(+) and negative (–) poles correctly.
•The battery is exhausted or no battery is installed. Install a new battery.
•If no indicators appear after installing a new battery, the camera is broken. In this case, contact
your nearest Nikon dealer or a camera shop for repair.
•You are out of the remote control working range. Move closer to the camera.
•If the remote control is exposed to direct sunlight or other strong light, change the location of
the remote control.
•The battery in the remote control is exhausted. Do not attempt to replace the battery yourself,
but go to a Nikon service center.
•Press the MODE button once again until
controller is not used for more than approx. 2 minutes.
+
Check this
" " appears on the LCD panel if the remote
@ C
P. 30)
Ref. page
E
9
9
–
26
26
–
26
33