Clatronic wk 2533 Bedienungsanleitung Seite 24

36900-05-WK 2533
GB
Before using the machine for the first time water should be boiled in it twice without
any additives.
1. Place the machine on a flat surface.
2. Open the water boiler with the button on the lid. Fill it with water. Do not overfill!
3. Place the kettle flush on the base.
4. Electrical connection
• Check whether the electrical voltage that you intend to use is the same as
that of the machine. Details are to be found on the label on the base.
• Only connect the machine to a properly installed 230 V, 50 Hz safety socket.
5. Switch on the appliance with the switch under the handle. The LED will light up.
6. After boiling the machine switches off automatically. Disconnect the machine
from the mains electricity supply. When pouring, do not press the lid too much.
Danger of burns!
• Always remove the plug from the mains supply before cleaning the machine!
• The exterior of the machine should be cleaned, if necessary, with a slightly
damp cloth without additives.
• All limestone deposits can be washed from the removable nylon filter under run-
ning water.
The decalcification intervals depend on the hardness of the water and the frequen-
cy of use. Decalcification should be carried out every 3 to 4 months.
If the machine switches off before the water boils, it probably needs to be decalci-
fied.
Please do not use vinegar but a commercially available decalcification agent on the
basis of citric acid. Only use the quantities stated in the instructions.
This appliance conforms with the CE directives for radio interference suppression
and low-voltage safety and has been built to meet current safety requirements.
Subject to technical changes without prior notice!
24
04.03.2004 9:18 Uhr
First Use of the Machine
Cleaning
Decalcification
Seite 24