Use; The Control Panel - Zanussi tce 7224 Gebrauchsanweisung

Use

The control panel

CONDENSER DRYER
E L E C T R O N I C
A B C D E
1
1 Programme guide
This will help you to select the correct programme for
drying.
2 Mains-ON light
Comes on when the appliance is switched on
(ON/OFF button pressed down) and goes out when
this button is released.
3 ON/OFF button
This button is used to switch the dryer on. At the end
of the programme, release this button by pressing it
again to switch the dryer off.
4 Low temperature button
Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light comes on.
This option can also be used for time controlled
drying.
The dryer heats at 1400 W instead of 2200 W.
If the button is not pressed, drying is performed at
full power (2200 W).
5 Buzzer OFF button
A buzzer sounds by depressing the pushbuttons,
during the anti-creasing phase, at the end of
programme and when the water reservoir is full.
Press this button when selecting the programme if
you wish to switch the buzzer off during the anti-
creasing phase. The corresponding light illuminates.
S E N S O R
F G H J K L
2 3
A U T O R E V E R S E
4 5
6 Start button
Press this button for about 2 seconds to start the
dryer after having selected the programme.
If the door of the appliance or the small door
covering the condenser is opened while the
programme is running, this button must be
pressed again after closing the door in order to
restart the programme from the point at which it
was interrupted.
This button must be depressed also after a power
failure and after having re-inserted the water
reservoir, if it has been emptied in the middle of a
programme.
In both cases light
flashes to remind you that the start button needs to
be pressed again.
7 Programme phase indicator lights
These lights indicate the various phases of the
programme as they are being performed.
"Drying" light
This light indicates that the appliance is in the drying
phase.
"Cooling" light
This light indicates that the appliance is in the
cooling phase. At the end of drying, there is a 10
minute cooling phase to cool the laundry.
If light or
button needs to be pressed again for the
programme to resume.
"End of programme" light
This light flashes at the end of the cooling phase and
during the anti-creasing phase.
6
0
6 7 8
or (depending on the
phase in progress)
is flashing, this means that the Start