Adjusting Suction Power - Philips FC8439 Bedienungsanleitung

English
8
- You can carry the vacuum cleaner horizontally by the handle on top of the appliance.

Adjusting suction power

You can adjust the suction power while vacuuming.
1 Adjust the suction power with the electronic suction power knob (Fig. 16).
- Turn the knob to MAX for maximum suction power (Fig. 17).
Use maximum suction power to vacuum very dirty carpets and hard floors.
- Turn the knob to MIN for minimum suction power.
Use minimum suction power to vacuum curtains, table carpets, etc.
storage
1 Switch off the appliance and remove the mains plug from the wall socket.
2 Press the cord rewind button to rewind the mains cord (Fig. 18).
3 Put the appliance in upright position and insert the ridge on the nozzle into the slot to attach
the nozzle to the appliance (Fig. 19).
replacement
Always unplug the appliance before you replace the dustbag or the filters.
Replacing the dustbag
- Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i.e.
even when the nozzle is not placed on the floor (Fig. 20).
1 Switch off the appliance and open the dustbag compartment cover (Fig. 21).
2 Push the dustbag holder backwards (Fig. 22).
3 Pull the cardboard tag upwards to remove the full dustbag from the holder. The dustbag is
sealed automatically (Fig. 23).
4 Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder.
Press it down as far as possible (Fig. 24).
5 Pull the dustbag holder forwards ('click') (Fig. 25).
If you have not inserted a dustbag, you cannot close the dustbag compartment cover.
Replacing filters
motor protection Filter
Replace the Motor Protection Filter once a year.
1 Switch off the appliance and open the cover. Remove the filter.
2 Insert a new filter into the holder with the white side pointing towards the dustbag
compartment (Fig. 26).
Super Clean Air Filter (specific types only)
Replace the Super Clean Air Filter every 6 months.
1 Open the grille at the back of the appliance and remove it (Fig. 27).
2 Remove the old filter. Place the bottom edge of the new filter properly behind the ridges on
the inside of the grille (1). Then push the top of the filter down into the grille (2) (Fig. 28).
3 Reattach the grille to the vacuum cleaner. First hook the bottom edge of the grille into the
appliance (1) and then push the grille towards the appliance (2) until it snaps home.