Philips FC9176 Bedienungsanleitung Seite 15

2 Press the filter holder release tab (1) and take the filter holder out
of the appliance (2). Take the motor protection filter out of the filter
holder.
3 Shake the filter over a dustbin to clean it.
4 Put the clean filter back into the filter holder. Fit the two lugs of
the filter holder behind the ridge at the bottom to ensure that it fits
properly at the top (1). Then press home the filter holder ('click') (2).
5 Place the dustbag holder with the dustbag back into the appliance.
Super Clean Air HEPA 12 filter/Ultra Clean Air HEPA 13 filter
This appliance is equipped with either the Super Clean Air HEPA 12 filter
or the Ultra Clean Air HEPA 13 filter. These filters are located in the back
of the appliance. They are able to remove 99.5% and 99.95% respectively
of all particles down to 0.0003mm in size from the outlet air. This not
only includes normal house dust, but also harmful microscopic vermin
such as dust mites and their excrements, which are well-known causes of
respiratory allergies.
Note: To guarantee optimal dust retention and performance of the vacuum
cleaner, always replace the HEPA filter with an original Philips filter of the
correct type (see chapter 'Ordering accessories').
Super Clean Air HEPA 12 filter
Replace the Super Clean Air HEPA 12 filter every six months. This filter is
not washable.
1 Open the filter grille.
2 Remove the old filter.
3 Insert the new filter into the appliance.
English
15