Safety Advice - Felisatti VCF32/1200 Bedienungsanleitung

English
Product
Type
Read the operating manual carefully before starting to use the vacuum
cleaner. It provides important instructions for the operation, safety, care and
maintenance. Keep the operating manual in a safe place and, in case you
sell the unit, hand it on to the next owner.
The manufacturer reserves the right to carry out modifications to the design
and equipment.
Any other work not covered by this operating manual must not be carried out.
Electro-technical tests must be carried out in accordance with the
accident prevention regulations (BGV A3) and in accordance with
DIN VDE 0701 Part 1 and Part 3. These tests are required in accordance with
DIN VDE 0702 at regular intervals and after repair or modification.
A dust-technical check must be carried out at least once a year by the
manufacturer or a trained person, e. g. for damage to the filter, dust-tightness
of the vacuum cleaner, function of the monitoring equipment.
The vacuum cleaners are successfully tested in accordance with IEC/
EN 60335–2–2.

1 Safety advice

The vacuum device is designed for industrial use.
Ideal in combination with an electric tool, on building sites, in
workshops, etc.
Danger
1.1
L
●Keep packaging material such as plastic bags away from
children.
▶ Never stand or sit upon the vacuum device.
▶ Particular caution is advised when ascending stairs. Pay
attention to standing safely.
▶ Do not pull the suction hose and connection line over sharp
edges, kink it or shut it.
▶ Always lay the suction hose and connection line so that nobody
may trip over them.
▶ In case of any leakage of foam or liquid, immediately switch off
the vacuum device.
▶ Always keep dry the inside of the lid.
▶ Do not start the vacuum device including its accessories if:
●the vacuum device shows detectable damage (fissures/
cracks);
●the power connection line is defective or shows fissuring or
ageing; or
●any invisible defect is suspected (after a fall).
▶ Do not allow the rotating brushes to get into contact with the
power connection line.
▶ Do not operate the vacuum device where there is danger of
explosions.
8 - GB
Vacuum cleaner for wet
and dry applications
VCF20/1000
VCF32/1200
VCF45/1400
Original operatin instructions in German
▶ Keep away the vacuum device from inflammable gases and
substances.
▶ Do not aspirate any combustible or explosive solvents, materials
soaked in solvents, explosive dusts, liquids such as petrol, oil,
alcohol, diluents or materials hotter then 60 °C (140 °F).
▷ Otherwise there will be danger of fire and explosions!
▶ Use the socket of the vacuum device only for the purposes
defined in the instruction manual.
▶ In case of any inappropriate usage, improper operation or repair,
the producer shall be exempt from liability.
▶ Do not use any damaged extension lines.
▶ If the connector line of the vacuum device has been damaged, it
must be replaced with a special connector line which is available
from the producer or their service.
▶ Electric brushes: Do not allow the rotating brushes to get into
contact with the power connection line.
▶ The voltage on the type sign must correspond to the grid
voltage.
▶ After every use and before any maintenance, switch off the
vacuum device and pull the power plug.
▶ Pull on the plug only, not on the line.
▶ Never plug or pull the power plug with wet hands.
▶ The socket must be secured via a household fuse with a
suitable current rating.
▶ Never open the vacuum device outdoors in rain or storm.
▶ Have repairs been made only by experts, e. g. the producer's
service. Use original spare parts only.
▶ Improperly repaired devices pose a hazard for the user.
1.2 WARNING
L
▶ Persons (including children) who are, due to their physical, sen-
sory or intellectual abilities or lack of experience or knowledge,
unable to safely use the vacuum device should not use it without
supervision or instruction by a responsible person.
▶ Particular caution is advised with children, elderly or infirm
persons.
▶ Do not point nozzle, tube or hose at people or animals
▶ Use only the brushes supplied with the vacuum device or
defined in the instruction manual. Use of any other brushes may
pose a safety hazard.
▶ Clean and disinfect the vacuum device immediately after use to
prevent microbial contamination due to long-term failure to clean
it, especially when using the device in food-processing.
▶ Do not use any steam jets or high-pressure cleaners for
cleaning.
▶ Acids, acetone and solvents may corrode parts of the vacuum
device.
▶ Do not leave the device without supervision. In case of longer
interruptions of work, pull the power plug.
▶ Do not clean filter cassettes with compressed ai
▶ Acids, alkalis and solvents can corrode the vacuum cleaner
parts.
▷ Clean the container and accessories with water.