Operating - Märklin Starter Set 29184 Bedienungsanleitung

Notes about Batteries and Rechargeable
Batteries
• Non-rechargeable batteries may not be charged up.
• Remove run down batteries from the battery pack.
• Remove rechargeable batteries from the battery
pack before charging them!
• Rechargeable batteries should be charged up
only under the supervision of adults.
• Inequality of battery types, or new and used
batteries may not be used together.
• Batteries with the correct polarity insert.
• Contacts should not be shorted.
• Batteries do not belong in the garbage!
• Every user in the European Union is legally
responsible for disposing of batteries at a coll-
ection point in his community or at the dealer.
The batteries are then passed on for environ-
mentally friendly processing.
• Batteries containing dangerous materials are
identified by these marks and chemical symbols
(Cd = cadmium, Hg = mercury, Pb = lead).
Please keep these instructions. They contain
important information.
Put the cover for the battery holder back in
place and screw it down.

7. Operating

7.1 Preparing the Train
Place the low side car on the track. Lay the load
frame on the load surface and set the rolls of wire
on it.
12
2
1
Set the rest of the train on the track and couple it
together.
7.2 Selecting an address:
(See Section 8 for the appropriate address for
your locomotive.)
Switch Address
• 78
• • 72
• • • 60
• • • • 24
Correct address selected? (See section 8)
When operating the IR Control, always line it up
with the lens in the direction of the Base Station.
Press the desired button.
Braking
* if the locomotive is designed for this
If no other commands are sent within 3 minutes of
the last command, the base station shuts off the
voltage in the track for safety reasons.
If the IR Control is activated again after that, the
base station will turn itself on automatically.
2
1
Turning on the
light
Controlling
Functions
1 – 4 *
Accelerating
Changing
direction