Electrolux zb 274 Anleitung Seite 7

English
Unpacking and assembly
Check that all the parts are in the box.
1. Attach the handle by carefully inserting it into the brush compartment.
Take care to ensure that the cable does not get jammed.
2. Secure the handle by tightening the locking screw supplied.
3. Snap the charging handle into the charging station and mount it on a
wall or similar. Mount/position the charging station close to a mains
socket (not near a heat source or wet spaces) and insert the adaptor into
the mains socket.
4. Alternatively the charging handle can be directly connected to the
handle.
Charging
5. Connect Ergorapido to the charging station (NB – always ensure
the Ergorapido is turned off). The indicator light will come on once
Ergorapido makes contact with the charging station. It takes 8-10 hours
to fully charge the batteries before the fi rst use. When Ergorapido is
totally discharged, approximately 12-16 hours charging is required to
regain full capacity. In order to ensure that it is always ready for use,
Ergorapido should be left on charge when not being used.
The adaptor may become warm during charging – this is normal.
Cleaning fl oors
You should regularly check that the nozzle cushions and the brush roller are
clean in order to avoid scratching sensitive fl oors
6. Start Ergorapido by pressing the on/off button once.
Stop by pressing the on/off button once again
Emptying/cleaning
7. Turn off Ergorapido, open the top cover and carefully lift out the dust
container.
8. Open the lid of the dust container and empty the contents into
a suitable vessel or bag.
Never wash the dust container in a dishwasher.
Cleaning the roller brush
9. If the roller brush becomes blocked or jammed for any reason, the
indicator light will go out. The roller brush may then need to be cleaned.
First turn off the Ergorapido, then carefully use a pair of scissors or a
sharp knife to remove any items such as threads that may have become
entangled.
10. If the roller brush needs to be lifted out – open the hatch cover using a
screwdriver or something similar and lift it out.
11. Lift out the roller brush and clean it.
Replace the roller brush and make sure it can spin freely.
Reassemble the hatch cover.
Cleaning of wheel axles
If a wheel is jammed by threads or dirt:
12. Remove the wheel by carefully prizing free the wheel brackets using
a screwdriver inserted into the cavity.
Remove threads or any other objects that may have become jammed
in the wheel axles.
Reassemble the wheel and press the wheel brackets together.
NB:
• Never use Ergorapido in wet places.
• Never use Ergorapido near fl ammable gases, liquids etc.
• Never brush sharp objects such as shards of glass or suchlike.
• Never use Ergorapido on liquids, as these can damage the machine.
• Never brush ash, lit cigarette ends etc.
• Never brush fi ne dust from plaster, concrete, fl our or ash, for example.
• Do not leave Ergorapido in direct sunlight.
• Avoid exposing Ergorapido or the battery to strong heat.
• The battery must not be dismantled, short-circuited, placed against a
metal surface or exposed to strong heat.
• Make sure Ergorapido is always turned off when emptying/cleaning.
Disposal
If an Ergorapido is to be disposed of, the batteries should be removed.
Used batteries should never be disposed of with household waste.
These should always be taken to a recycling station.
Taking out batteries
13. NB – Ergorapido must not be connected to the charging station while
the batteries are being removed. Open the battery cover and lift out the
batteries. Pull the fl at pin connectors from their brackets.
Servicing or repairs
In cases of breakdown or faults, your Ergorapido must be taken to an
authorised Electrolux service centre.
5