2-4. Service Position
Position the chassis as indicated to access the solder side.
To gain access to the underside of the boards follow the
instructions on page 16. [Removal and Replacement of the
main bracket bottom plates ].
2-6. F4 Bracket Removal
Clip
Release the clips circled and pull the bracket towards the rear of
the set. The bracket can then be removed to allow access to the
boards.
2-5. D and G Board Removal
To remove the G Board release the clips circled and ease the
board gently away from the support bracket. Removal of the
D Board follows the same procedure.
2-7. F4 and H1 Board Removal
Clips
To remove the F4 and H1 Boards release the clips circled and
ease the boards gently away from the support bracket.
- 13 -
Clips
Clips