Kampa Rally AIR Anleitung Seite 7

Before using for the first time please check the contents of your awning
Awning
Hand Pump
Peg Bag
Draught Skirt
Carry Bag
If you are missing any parts please contact your supplying dealer.
Siting
Choose a site that is flat and, if possible, protected from the wind. Sloping ground may
have an adverse affect on your finished awning.
Set Up
To protect your awning from dirt and damage, it may be beneficial to lay a groundsheet
or awning carpet down before unpacking. Unpack the awning, separate and identify the
different parts.
Slide the awning beading, on the rear of the awning roof (see Diagram 1), through
the caravan awning channel until it is in your required position. The awning should be
positioned on a horizontal part of the caravan (see Diagram 2). Ensure all removable
panels are fully zipped into the awning.
Peg the webbing strap rear corners of the awning (3a/3b where applicable). Each corner
should be pegged under the caravan to pull the awning as close to the caravan as
possible. Locate the eyelet (4) on the webbing straps close to the rear pegging points
(Rally only not Rally Pro). Take a line vertically from the edge of your caravan and peg
the eyelet in this position. This will regulate the distance to the poles at the front of the
awning. Locate the deflation valves at the bottom of each of the AirPoles (5). Ensure that
the deflation valves are closed by turning the tap to a 90° angle (as shown in Diagram 5).
Locate the inflation valve on the awning. Ensure that the valve is screwed tightly into the
AirPole by turning the outer ring (6).
Important
It is important that whilst turning this ring the valve does not spin in the AirPole, you can
prevent this from happening by holding the valve in place where it meets the AirPole.
If the valve spins it will twist the inflation tube in the pole and may lead to premature
failure. If you suspect this has happened do not inflate your awning before untwisting
the tube. Unscrew the valve from the AirPole and check that the inflation tube is not
twisted. Before replacing the valve ensure that the black sealing washer is in place. It is
not normally necessary to remove this valve in day to day use.
WARNING
NEVER OPEN THE ZIP ON THE GREY INNER TUBES WHILST THE
POLES ARE INFLATED. THIS WILL RESULT IN THE POLE BURSTING.
AWN-AIR-UM-0715
7
1
1
1
1
1