Sharp XG-MB70X Serviceanleitung Seite 46

XG-MB70X
Resetting after replacing IC8003 (EEP ROM)
MAC address returns to default. Follow the steps below to reset.
1 Open the top cabinet of the projector and confirm the MAC address (MAC: ************) of the seal on the PWB.
2 Connect the control PC and projector with a RS-232C cable.
3 Turn on the AC power supply.
4 EEP ROM returns to default.
5 Turn off the AC power supply and turn on again.
6 Set MAC address by using the RS-232C command. (Refer to "MAC address setting" for the setting procedure.)
7 Enter
Check that it is the same as the set MAC address.
8 Setting is completed.
MAC address setting
RS-232C commands to be used
1 Enter
Responds "OK".
2 Enter
Responds "OK".
3 Enter
Responds "OK".
4 Enter
Responds "OK".
5 Enter
Responds "OK".
6 Enter
MAC address setting is completed.
and check the response.
*1 1st byte of the MAC address
*3 3rd byte of the MAC address
*5 5th byte of the MAC address
*7 7th byte of the MAC address
*9 9th byte of the MAC address
*11 11th byte of the MAC address
and [*2], and press "ENTER".
and [*2], and press "ENTER".
and [*2], and press "ENTER".
and [*2], and press "ENTER".
and [*2], and press "ENTER".
and [*2], and press "ENTER".
46
*2 2nd byte of the MAC address
*4 4th byte of the MAC address
*6 6th byte of the MAC address
*8 8th byte of the MAC address
*10 10th byte of the MAC address
*12 12th byte of the MAC address