General Characteristics - PeakTech 4055 MV Bedienungsanleitung

5.1.6. FM, AM, PM, PWM:
Carrier waveform
Modulation waveform
Modulation frequency
Frequency offset
Modulation amplitude depth
Phase offset
Pulse width deviation
5.1.7. FSK:
Carrier waveform
Modulation waveform
FSK rate
Hop frequency
Trigger source
5.1.8. Burst:
Waveform
Repeated period
Pulse count
Start phase
Trigger source
5.2. Sync-Output characteristics
Waveform characteristics:
Amplitude characteristics:
5.2.1 Programmable interface:
USB device interface, of which the operation guide is on the CD attached with the generator.
5.3. Power amplifier
Input Signal
Maximum output voltage
Frequency bandwidth:
Voltage Amplifier
Maximum output power

5.4. General characteristics

Power conditions
Environment conditions
Operation characteristics
Display mode
Dimensions (WxHxD)
Weight
16 kinds of waveforms including sine, square, ramp, etc.
(PWM only for pulse)
16 kinds of waveforms including sine, square, ramp, etc.
40 mHz ~ 20 kHz
10 μHz ~ 3 MHz
P 4055
10 μHz ~ 20 MHz
P 4060
0%~120%
0°~360°
0%~99%
16 kinds of waveforms including sine, square, ramp, etc.
Square
40 mHz ~100 kHz
10 μHz ~ 3 MHz
P 4055
10 μHz ~ 20 MHz
P 4060
Internal continuous, external signal
16 kinds of waveforms including sine, square, ramp
1 μs ~ 20 s
1 ~1000000
0°~ 360°
Internal continuous, external signal, manual trigger
Square, edge time
Compatibility of TTL, CMOS
0 Vrms to 4.5 Vrms
9 Vrms
100 Hz ~ 10 kHz
Double
10 W (load 8)
Voltage
Frequency
Power
Temperature
Humidity
Fully keyboard operation, continuously adjust with adjusting knob.
VFD fluorescence display screen.
256 x 102 x 322 mm
1,5 kg
-55-
≤ 20 ns
low level < 0.3 V
high level > 4 V
100 ~ 240 V AC
45 ~ 65 Hz
< 20 VA
0 ~ 40 °C
<80% RH