Specifications; Frequency Characteristics - PeakTech 4055 MV Bedienungsanleitung

5. Specifications

5.1. Output characteristics of channel A
5.1.1. Waveform characteristics:
Waveform types
Waveform length
Sampling rate
Amplitude resolution
Harmonic distortion (1Vpp)
Total distortion of sine
Rising/Falling Edge time
Duty cycle of Square
Ramp symmetry

5.1.2. Frequency characteristics:

Frequency range
Resolution
Frequency accuracy
5.1.3. Amplitude characteristics:
Amplitude range
Resolution
Amplitude accuracy
Amplitude flatness
Output impedance
5.1.4. Offset characteristics:
Offset range
Resolution
Offset accuracy
5.1.5. Sweeping characteristics:
Waveform
Sweeping range
Sweeping rate
Sweeping mode:
Trigger source
Sine
Square
Others
10 µHz
±50 ppm
open circuit load
50  load
5 mVpp
0,5 mVpp
±(1% + 2 mVrms)
±10%
50 typical
16 types including sine, square, ramp, exponent,
noise and so on.
1024 points
100 MSa/s
8 bits
≤-40 dBc (<5 MHz)
≤-35 dBc (>5 MHz)
≤0,5 % (20 Hz ~ 20 kHz / 20 Vpp)
≤35 ns, over shoot: ≤ 10 %
0,1 % ~ 99,9 %
0,0 % ~ 100,0 %
P 4055
P 4060
P 4055
P 4060
<8 MHz
>8 MHz
<8 MHz
>8 MHz
for amplitude >2 Vpp
for amplitude <2 Vpp
frequency is 1 kHz / > 5 mVrms
Sine, compared to 1 MHz, 5 Vpp
±10 V DC (open circuit load)
±5V DC (50  load)
5 mV DC
±(1% + 20 mV DC)
16 kinds of waveforms including sine, square, ramp, etc.
the start/end point can be set arbitrarily
50 ms ~ 500 s
linearity, logarithm
internal continuous, external signal, manual trigger
-54-
10 µHz ~ 3 MHz
10 µHz ~ 20 MHz
10 µHz ~ 3 MHz
10 µHz ~ 5 MHz
10 µHz ~ 1 MHz
0 mVpp ~ 20 Vpp
0 mVpp ~ 18 Vpp
0 mVpp ~ 10 Vpp
0 mVpp ~ 9 Vpp