Overview Of Available Classes - Relectronic CEV-58 Benutzerhandbuch

Parameterization

7.1 Overview of available classes

Object Classes
0x01: Identity Object
0x02: Message Router Object
0x04: Assembly Object
0x06: Connection Manager Object
0x23: Position Sensor Object
0x47: Device Level Ring Object
0x48: Quality of Service Object
0xF4: Port Object
0xF5: TCP/IP Interface Object
0xF6: Ethernet Link Object
Table 8: Overview of available classes
* corresponds to EtherNet/IP™ specification
 TR-Electronic GmbH 2013, All Rights Reserved
Page 114 of 175
Purpose
Contains all device specific data, such as
Vendor ID, Device type, Device status etc.
Contains the measuring system's supported
class codes and the max. number of
connections.
Returns the position value of the measuring
system.
Contains connection specific attributes for
triggering, transport, connection type etc.
Contains all attributes for programming the
measuring system parameter, such as
scaling and count direction.
DLR contains attributes for the status
information of the ring bus system.
QoS is a general term for mechanisms that
treat traffic streams with different relative
priorities or other delivery characteristics.
Therefore the EtherNet/IP™ messages are
marked with "Differentiated Services Code
Points" (DSCP)
Contains the available Ports, Port name and
Node address on the port.
Contains all attributes for the configuration
of the TCP/IP network interface such as IP
address, Subnet mask
Defines how the measuring system gets
these parameters: FLASH,
hardware switch.
Contains connection specific attributes,
such as Transmission rate, Interface status
and the MAC-Address.
TR - ECE - BA - DGB - 0102 - 08
Access
Get
Get
Get
Get
Set/Get
Get
Set/Get
Get
and Gateway.
Set/Get
DHCP or
Get
Printed in the Federal Republic of Germany
Page
115
*
118
*
123
151
154
*
156
162
07/14/2017