Configuration Assembly; Configuration Assembly Data Attribute Format - Relectronic CEV-58 Benutzerhandbuch

Object Model, Encoder Device

6.2.2 Configuration Assembly

"Configuration Assembly" is available ex firmware version 1.15 !
The Configuration Assembly summarized all important attributes from the position
sensor object. The attributes are transferred to the measuring system in the start-up
phase when a connection was established.
The attributes are programmed with their default values. If this is not desired, the
values of all parameters must be set to the value "0".

7.2.2.1 Configuration Assembly Data Attribute Format

Instance
150
Table 6: Configuration format
See also chapter 7.3.3.7 Attribute 3, Configuration Assembly on page 121.
 TR-Electronic GmbH 2013, All Rights Reserved
Page 112 of 175
Byte Attribute
Direction Counting Toggle
0
1
2
Measuring Units per Span
3
4
5
6
Total Measuring Range in Measuring Units
7
8
9
Velocity Format
10
11
12
13
14
Total Measuring Range
15
16
17
18
19
20
Number of Revoltions – Numerator
21
22
23
24
Number of Revoltions – Denominator
25
26
TR-Parameter in use
27
28
29
Reserved
30
31
TR - ECE - BA - DGB - 0102 - 08
Page
128
129
130
135
142
143
143
147
-
Printed in the Federal Republic of Germany
07/14/2017