Maintenance - Makita 4093D Betriebsanleitung

Cleaning (Suction)
Nozzle (Fig. 4)
Attach the nozzle to clean off tables, desks, furniture,
etc. Nozzle slips on easily.
Nozzle + Extension wand (Straight pipe) (Fig. 5)
The extension wand fits in between the nozzle and
the cleaner itself. This arrangement is convenient for
cleaning a floor while standing erect.
Corner nozzle (Fig. 6)
Fit on the corner nozzle for cleaning corners and
crevices of a car or furniture.
Corner nozzle + Extension wand (Straight pipe)
(Fig. 7)
In tight quarters where the cleaner itself cannot
squeeze in, or in high places hard to reach, use this
arrangement.
Cleaning without nozzle (Fig. 8)
You can pick up powder and dust without nozzle.
Dust disposal
CAUTION:
Empty the cleaner before it becomes too full, or the
suction force weakens.
Depress the buttons and open the front cover. (Fig. 9)
Take the dust bag out of the cleaner carefully so that
the contents will not spill out. Empty the contents out
of the dust bag. (Fig. 10)
Also empty out the dust inside the cleaner itself.
Failure to do so may cause the sponge filter to be
clogged or the motor to be damaged. (Fig. 11)
Installing dust bag
Place the dust bag into the cleaner cavity. (Fig. 12)
Insert the holder of the dust bag all the way into the
slots in the cleaner cavity. (Fig. 13)
CAUTION:
Forgetting to install the dust bag, failure to insert the
holder of the dust bag all the way into the slots or
using a broken or ripped bag, may allow dust to get
into the motor. This may result in motor failure.
Hook the front cover onto the front lip of the cleaner.
Then close the front cover. (Fig. 14)
NOTE:
• When installing the paper pack, follow the same
procedures for the dust bag.
• Always unfold a new paper pack before installing it
on the cleaner.

MAINTENANCE

CAUTION:
Always be sure that the cleaner is switched off before
carrying out any work on the cleaner.
After use (Fig. 15)
When storing the cleaner, hang it from a nail using the
convenient hanger in back.
Cleaning (Fig. 16)
From time to time wipe off the outside (cleaner body)
of the cleaner using a cloth dampened in soapy water.
Never use gasoline, thinner or the like. Discoloration
or cracks may result.
Wash the dust bag in soapy water occasionally. Dry it
out thoroughly before use. An insufficiently dried bag
may cause poor suction and shorten the service life of
the motor.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
5