EN
present, the transmitter no longer has the correct information to connect to a
specific receiver and in essence the transmitter has been "unbound" from the
receiver. We've had several DX7 customers that use transmitter stands or trays
that unknowingly depress the bind button and the system is then turned on
losing the necessary information to allow the connection to take place. We've
also had DX7 customers that didn't fully understand the range test process
and pushed the bind button before turning on the transmitter also causing the
system to "lose its bind."
If the system fails to connect, one of the following has occurred:
• The transmitter is near conductive material (transmitter case, truck bed,
etc.) and the reflected 2.4GHz energy is preventing the system from
connecting. (See 2nd question above)
• The transmitter was put into bind mode knowingly (or unknowlingly)
causing the transmitter to no longer recognize the receiver.
Limited Warranty
What this Warranty Covers
Horizon Hobby, Inc., (Horizon) warranties that the Products purchased
(the "Product") will be free from defects in materials and workmanship
at the date of purchase by the Purchaser.
What is Not Covered
This warranty is not transferable and does not cover (i) cosmetic damage, (ii)
damage due to acts of God, accident, misuse, abuse, negligence, commercial
use, or due to improper use, installation, operation or maintenance, (iii)
modification of or to any part of the Product, (iv) attempted service by anyone
other than a Horizon Hobby authorized service center, or (v) Products not
purchased from an authorized Horizon dealer.
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORIZON MAKES NO OTHER
WARRANTY OR REPRESENTATION, AND HEREBY DISCLAIMS ANY AND ALL
IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED
WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE. THE PURCHASER ACKNOWLEDGES THAT THEY
ALONE HAVE DETERMINED THAT THE PRODUCT WILL SUITABLY MEET THE
REQUIREMENTS OF THE PURCHASER'S INTENDED USE.
Purchaser's Remedy
Horizon's sole obligation and purchaser's sole and exclusive remedy shall be
that Horizon will, at its option, either (i) service, or (ii) replace, any Product
determined by Horizon to be defective. Horizon reserves the right to inspect
any and all Product(s) involved in a warranty claim. Service or replacement
decisions are at the sole discretion of Horizon. Proof of purchase is required for
all warranty claims. SERVICE OR REPLACEMENT AS PROVIDED UNDER THIS
WARRANTY IS THE PURCHASER'S SOLE AND EXCLUSIVE REMEDY.
Limitation of Liability
HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL
OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS OR PRODUCTION OR