Hitachi CP-X10000 Bedienungsanleitung Seite 155

Daisy Chain Communication
Command data
① Control the projector
byte_0
Action
low
Action (byte_0-1)
Action
1
4
5
6
Note: For the Type and Setting Code, see the RS-232C communication/
Network command table (
② Get the projector's status
byte_0
Action
low
Action (byte_0-1)
Action
2
Connection ID (byte_4-5)
Connection ID
0~255
③ Other commands
byte_0
Action
low
Support Command
Get the number of connected projectors
Set the communication Group
identifi cation and Communication ID
Get the communication Group
identifi cation and Communication ID
16
byte_1 byte_2
high low
Classifi cation
Set Change setting to desired value.
Increment Increment setup value by 1.
Decrement Decrement setup value by 1.
Execute Run a command.
20).
byte_1 byte_2
high low
Classifi cation
Get Read projector internal setup value.
This value is attached to the reply data.
byte_1 byte_2
Target Number
high low
byte_3
Type
high
Content
byte_3
Type
high
Content
Content
byte_3
high
Action Target Number Connection ID
2
1
2
byte_4 byte_5
Setting Code
low
byte_4 byte_5
Connection ID
low
byte_4 byte_5
Connection ID
low
0
0~65535
0~65535
high
high
high
0~255
0~255
0~255