General Information; Technical Data; Explanation Of Symbols - HSK HSK23 Bedienungsanleitung

Bedienungs- und Wartungsanleitung für Handschweißextruder Serie HSK23/HSK30

1. General information

Copyright holder of this documentation is HSK Kunststoff Schweisstechnik GmbH,
Bad Honnef. It contains descriptions, technical drawings and enclosures which may
not, neither partly nor entirely, be copied, distributed, used for competitive reasons or
given to third parties without their permission.
These instructions have to be studied thoroughly prior to the start-up of the machine,
as the manufacturer will not accept any liability for damage to persons and/or
machine parts resulting from handling not in line with these directions.
These operating instructions are made for the practical use and should therefore be
accessible to the operator at any time.
Please make sure that prior to repair and maintenance work at the welding extruder,
the device must absolutely be disconnected from the electrical network.
On ordering spare parts the following specifications must be procured:
All necessary settings and, if necessary, adjustments to be carried out by skilled
workers are described in the present operation manual. Should there, in spite of this
fact, occur problems during start-up, we would ask you not to carry out unauthorized
manipulations to the machine. You will endanger your health and risk to loose
warranty. In this case please contact the nearest sales agency or get in direct contact
with HSK K
UNSTSTOFF

2. Technical data

Voltage:
Air heating:
Cylinder heating:
Extruder drive:
Air volume / min.:
welding wire max. Ø:

3. Explanation of symbols

Information of special importance in the present operating instructions is marked with
the following symbols:
Information regarding security:
Information regarding maintenance:
24
 HSK Kunststoff Schweißtechnik GmbH
1. Machine-no.
2. Device (Extruder, drive or air heater)
3. No. of item corresponding to the spare parts list (see p. 12)
S
CHWEIßTECHNIK
230 V / 50 Hz
2.200 W
700 W
740 W
300l/min at 0,6 bar only machines with separate air supply
HSK30 - 4mm / HSK23 – 5mm
G H (see page 38).
MB