Decoder Functions And Cv Settings; Cv Table For Fx (Mm) - Märklin 60972 Handbuch

Decoder functions and CV settings

The following pages have the functions and the CVs presented in
tabular form. These CVs can be given a number of settings and
can be assigned to a number of function buttons.
You'll find the CVs and their applications for the track formats fx
(MM) and DCC in separate tables.
The track format mfx can be easily set by using the display
CV
Explanation
1
Address 1 (main address)
2 Minimum speed (Vmin)
3
Acceleration delay (AV)
4
Braking delay (BV)
5 Maximum speed (Vmax)
7
Automatic Calibration
8
Decoder reset (default or factory setting)
17
Address 3 (2nd consecutive address)
18
Address 4 (3rd consecutive address)
* () = 6021 Control Unit {} = the values entered are multiplied times "x" (factor)
30
on the CS 2 with Software Version 2.0 and higher. You or your
dealer may have to install an update on your 60213/60214/60215
Central Station.

CV Table for fx (MM)

Values Default
78
1-255 (1 - 80)*
1-255 (1 - 80)* 4
12
1-255 (1 - 80)*
12
1-255 (1 - 80)*
1-255 (1 - 63)*
180
{x4}*
77
8
254
1-255 (1 - 80)*
253
1-255 (1 - 80)*
.
Notes
Address is always active and is not subject
to CV 49..
Speed at the smallest speed level. Value
must be smaller than Vmax, CV 5.
CV value multiplied by 0.25 gives the time
from complete stop to maximum speed.
CV value multiplied by 0.25 gives the time
from Maximum speed to complete stop.
Speed at the highest speed level. Value must
be greater than CV 2.
Enter Value 77. Value 77 is not stored
continuously.
Value is not written.
Address can be deactivated/activated
subject to CV 49.
Address can be deactivated/activated
subject to CV 49.