Physical Functions; Logic Functions; Controllable Functions - Märklin 60972 Handbuch

Physical Functions

Each of these functions must be connected externally to the
circuit board. We therefore speak of physical functions. A
unique mode/effect can be assigned to each physical output
(AUX / lights) in digital operation. Three CVs are available for
each output for this purpose. Only one mode/effect can be set
for each output. A complete table for this can be found on the
Internet at:
http://www.maerklin.de/de/service/technische-informationen

Logic Functions

Since these functions are only executed by software, no
physical output is required for them. We therefore speak here of
a logic function.

Controllable Functions

Headlights
Aux 1
Aux 2
Switching Range
ABV out
Aux 3)
Aux 4
function/off
f1 Funktion 1
f2 Funktion 2
f3 Funktion 3
f4 Funktion 4
— —
— —
Acceleration/Braking Delay
• The acceleration and braking time can be set separately from
each other.
• The logic function ABV can be assigned to any function button
by using the function mapping.
Switching Range (RG)
• The switching range causes a reduction in the current speed
of the locomotive. This allows a fine touch in the controlling
the locomotive. The switching range can be assigned in mfx
and DCC to any function button by using the function mapping.
See table on page 37 for setting CV, CV 145 or mfx menu for
the Central Station.
F0
1 5
systems
STOP
mobile station
Funktion f0
Funktion * Funktion f1
Funktion * Funktion f2
Funktion * Funktion f3
Funktion * Funktion f4
Funktion * Funktion f5
Funktion * Funktion f6
* Function symbols may be displayed in different order.
f0 f8 f8 f0
F4
Digital/Systems
Funktion f0
Funktion f1
Funktion f2
Funktion f3
Funktion f4
Funktion f5
Funktion f6
29