Märklin 60760 Handbuch Seite 7

Setting locomotive parameters with the
Control Unit
1. Requirement: Setup as in diagram on page 14.
Only the locomotive to be changed can be on the
track.
2. Press the "Stop" and "Go" at the same time until
"99" blinks in the display.
3. Press the "Stop" button.
4. Enter the locomotive address „80".
5. Hold the speed control knob in the reverse
direction position constantly. Press the "Go" button
while you do this.
6. The headlight on the locomotive will blink. If no,
repeat starting at Step 2.
7. Enter the register number for the parameter to be
changed (=> List on page 16).
8. Activate the direction reversal.
9. Enter new value (=> List on page 16).
10. Activate the direction reversal.
11. End the procedure by pressing the "Stop" button.
Now press the "Go" button.
Setting locomotive parameters with the Mobile
Station
A entry must be selected from the database to
change the locomotive parameters, and this entry
must be one that allow changes to the parameters
(example: 55742, 36850). Note the following at all
times:
• Only the locomotive to be changed may be recei-
ving power from the Mobile Station, when you are
changing parameters.
• Parameters that can be set: Address, acceleration
and braking delay, maximum speed, Locomotive
Reset (Resetting the locomotive back to its factory
settings)
• The acceleration and braking delay are changed
together in the submenu "ACC".
• After you have changed the address, the address in
the entry in the locomotive list must also be chan-
ged to the new value, if this entry does not support
external programming of decoders.
Tip: The database in the Mobile Station can be
updated. To do this, simply connect the Mobile
Station with an adapter cable to an updated Central
Station, and wait several minutes. When a Mobile
Station is being updated, it loses all of the entries in
the locomotive list!
Setting locomotive parameters with the Central
Station
Please see the notes in the instructions for the
Central Station.
7