Märklin 60760 Handbuch Seite 5

Check to make sure the retrofit kit is suitable for the
locomotive you are converting:
• Is the type of locomotive right for the kit?
• Is the type of motor right for the kit?
• Is the locomotive in good mechanical condition?
• What electrical load does the locomotive place on
the kit?
• What special technical features does the locomo-
tive have?
Note: The conversion may be performed only by
authorized, trained personnel (example: authorized
Märklin Digital dealer). In all other instances the
warranty will become null and void.
Determining the Auxiliary Functions.
Maximum load on the motor outputs: 800 milliamps
Maximum load on the function outputs: 150 milliamps
Maximum load for the complete decoder: 1.100 milliamps
=> maximum of 2 no. 610 080 (19 V) light bulbs or 1
no. 610 040 (16 V) light bulb per function output
Preparing / Installing the Motor
Step 1: Remove the brush plate, armature, field,
electronic circuit or reverse unit.
Note: Remove all interference suppression capacitors
(C2 and C3) on the motor! There can be no ground
connection from the motor through interference sup-
pression elements to the locomotive's frame!
Step 2: Check the gear train for wear and to make
sure it is free running.
Step 3: Install the new permanent magnet field,
armature, and brush plate.
Wiring
1. Connect the power wires (red, brown) and the
motor wires (green, blue). Don't forget the chokes
on the connections to the motor!
2. Connect the headlights. Use the orange wire as a
ground only when the headlights have no electrical-
connection to the locomotive's frame!
3. Now changewires if necessary so that the head-
lights at each end are on when the locomotive is
going in that particular direction.
5