Resetting The Total Lamp Timer - Sharp XG-C40XU Anleitung

XG-C40XU/XE

RESETTING THE TOTAL LAMP TIMER

When the lamp has been replaced, reset the total lamp timer in the following steps.
Resetting procedure
1. While holding down the "ENTER", "ADJ."" and "ADJ.|" keys on the set at the same time, turn on the main
power switch (located side the AC inlet).
2. Now the total lamp timer is reset to zero. "000H" appears on the screen.
Lamp
The lamp in this projector operates for approximately 2,000 cumulative hours, depending on the usage environ-
ment. It is recommended that the lamp be replaced after 1,900 cumulative hours of use or when you notice a
significant deterioration of the picture and colour quality. The lamp usage time can be checked with the On-screen
Display.
CAUTION
• Intense light hazard. Do not attempt to look into the aperture and lens while the projector is operating.
• As the usage environment can vary significantly, the projector lamp may not operate for 2,000 hours.
Condition
The LAMP REPLACEMENT
indicator lights up red, and "LAMP"
and " " will flash in yellow in the
lower-left corner of the picture.
A significant deterioration of the
picture and colour quality occurs.
The power will automatically turn
off and the projector will enter
standby mode.
"LAMP" and " " will flash in red in
the lower-left corner of the picture,
and the power will turn off.
LAMP TEMP.
POWER
+
I
ON
MUTE
OFF
MENU
KEYSTONE
INPUT
'
FREEZE
ENLARGE
BLACK SCREEN ENTER
B
ENTER
Problem
• Lamp has been used for over 1,900
hours.
• Lamp has been used for over 2,000
hours.
18
VOLUME
AUTO
SYNC
RESIZE
GAMMA
UNDO
ADJ." ADJ.|
Possible Solution
• Purchase a replacement lamp unit
(lamp/cage module) of the current
type BQC-XGC40XU/1 from your
nearest Sharp Authorised LCD
Projector Dealer or Service Centre.
• Replace the lamp. If you wish, you
may have the lamp replaced at
your nearest Sharp Authorised
LCD Projector Dealer or Service
Centre.