Signal Output Connectors; Operating Instructions; Operating Procedures; Maintenance - LD DJ200 Bedienungsanleitung

7. Signal output connectors

Fig. 4: Signal output via Speakon connectors
Channel A and B signal output:
1+ / 2+ Connect (+) signal output to (+) speaker
1- / 2- Connect (-) signal output to (-) speaker
Attention: Improper connections will result in malfunctions. Ensure that the connections and operating mode
are correct before switching on the power.

8. Operating instructions

Operating procedures:

8） Connect the unit to appropriate speakers.
9） Ensure that all input and output connections are correct and secure.
10） Ensure that the mains power supply corresponds to the rated voltage indicated on the amplifier.
11） Connect the signal source, e.g. mixing console, to the signal input of the amplifier.
12） Set the input level (volume) of the amplifier to the lowest setting.
13） First switch on the power for the signal source, e.g. mixing console, then switch on the power for the
amplifier.
14） Adjust the input level (volume) to the desired volume.

9. Maintenance

1. Clean the unit by wiping it with a slightly damp cloth. Do not permit moisture to enter the unit. Do not use
alcohol or any volatile liquid cleansers that may damage the unit.
3. Clean the ventilation slots regularly with a vacuum cleaner. This maximises cooling by the amplifier fans
and helps to prevent overheating.
DJ200 PROFESSIONAL POWER AMPLIFIER USER MANUAL PAGE
Fig. 4
14/19 V-