Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
G.2
VFR code presetting
Press the SEL button (B) to get into configuration mode (selection is indicated in
the left bottom corner of the display under the operating mode indication).
(1)
Rotate (E) to the indication VFR=XXXX.
First push to button (F) ⇒ left digit of the code is inverted.
(2)
(3)
Now the digit can be changed with (E).
Second push to button (F) ⇒ next left digit of the code is inverted.
(4)
(5)
The next digit can be changed with (E)
(6)
and the same for next digits.
Fifth push to button (F) ⇒ again first digit is inverted.
(7)
(8)
Changes can be stored with STO button (C) at any time, inversion stops
in this case.
(9)
A VFR code that was preset in this way can be activated as described in
chapter I.
(10)
A timeout for inversion (10 sec) is introduced if no action happens. Nothing
stored, as long as (C) is not pressed.
NOTE:
It is possible to leave the setting procedure with SEL button (B) at any time and the
chosen mode is available then. Indication SEL on the display changes back to
mode indication. If STO button (C) was not used, no change has been stored.
H.
Flight operation in Mode A/C/S (reply code and altitude code)
(1)
When ATC requests the transmission "squawk", switch the transponder to
ALT using mode switch (A).
NOTES:
• This only makes sense if the transponder is connected to a coding
altimeter. If not, tell ATC that you do not have mode C ("mode charlie not
available").
• In exceptions the altitude has to be turned off, i.e. switch the transponder
to ON using mode switch (A).
Bedienung/Operation BXP6403-X-(XX)
Seite/Page 31 von/of 40
Werbung
Inhaltsverzeichnis
