Revox B261 Serviceanleitung Seite 33

srLrror=R
Rd/ox
8261 SA
sEcrtON
2/1
2.
DI SMANTLING INSTRUCTIONS
Caution: Disconnect power cord before removing cover plates!
2
.
I
Removi-ng
the top cover
(
Fiq.
2. I
)
-
Unfasten two screws LAlon
the rear.
- Slj-de
cover plate out toward the rear
2
-2
Removin
the bottom
cover
2.1
D
Fiq.
2.4
Fig. 2.5
- Unfasten 5 screws
I
Bl
- Careful-Iy slide cover
on the underside.
plate over apparatus pads.
2.3
Removing the side covers
- Unfasten two screws on each side
-
Remove
side panels
2.4
Removing
the front panel (Fig. 2.3 and 2.4)
- Perform steps 2.I,
2.2, and 2.3
- Pull- off all
5
knobs
- Unfasten two screws
I
C] on top of the tuner
(Caution: save ground springs and washers).
- Unfasten two screws IDj on the underside.
(
Save washers
) .
- Carefully slide off front panel.
2.5 Removing
the operating panel (Fig. 2.5)
- Perform steps 2.I, 2.2, 2.3 and 2.4.
- Detach six CIS connectors on the operating panel and the
flat-pin
terminal- (ground connection) on the chassis.
- Unfasten five screws IEl.
- Carefully pull off operating panel.
2.6
Replacing the meter j-flumination
l-amps
(Frg. 2.6)
- Perform step 2.1
- Loosen two screws [Fl on top of tuner.
- Pul-1
cover off toward the rear.
- Remove
lamp by lightly spreading the contact springs.
Fig.2.6