Samsung HT-F9750W Handbuch Seite 16

Connections
Installing the Speakers on the Tallboy Stand
1. Straighten the speaker cable and put it into the hole on the
Stand Base.
2. Turn the Stand Base upside-down and connect it to the
Stand.
3. Use the driver to combine the screws on the 3 marked
holes.
4. Connect the upper Speaker to the assembled Stand.
5. Insert a screw clockwise into the hole on the rear of the
speaker using a screwdriver.
6. This is the appearance after the speaker is installed. Follow
these steps to install other speaker.
Connecting The Speakers
1. Match each speaker cable bundle to the correct speaker by matching the colour coded
plug on each bundle to the coloured sticker on the bottom of each speaker.
2. To attach speaker wire to each speaker:
a. Press down the red tab on the back of the speaker, insert the red wire, and then
release the tab.
b. Press down the black tab on the back of the speaker, insert the black wire, and then
release the tab.
3. Connect the speaker wire plugs from each speaker to the back of the product by
matching the colours of the speaker plugs to the colours of the speaker jacks.
4. Connect the left and right surround speakers to the wireless receiver module.
Again, match the colour of the plugs to the jacks on the wireless receiver module.
5. Plug the power cord of the wireless receiver module into a wall outlet.
6. Turn on the product. The product and wireless receiver module will now communicate with each other and you will
hear sound from the Surround speakers.
16
|
English
2
1
Stand
3 4
Speaker
5 6
Black
Stand Base
Stand
or
Red