Playing Media - AEG DVD 4625 HC HDMI/USB Bedienungsanleitung

Terminology
Using the remote control
Loading a CD/DVD
Understanding the
onscreen CD-menu
05_DVD 4625 HC AEG - GB.indd 61 05_DVD 4625 HC AEG - GB.indd 61
Track: "Track" is the designation for sections on an Audio-CD. This
may be a song, the set of a symphony, etc.
Title/Chapter: Video-DVDs are divided into "Title" and „Chapters". A
„Title" may be e.g. a particular fi lm, the „Chapters" may be subsec-
tions of this fi lm.
HDMI: High Defi nition Multimedia Interface is an interface for
transmitting high-resolution digital video data and digital audio
data.
MPEG4: Your DVD player is also suitable for playing back fi les that
have been compressed using the MPEG-4 system (short for Moving
Picture Experts Group-4). MPEG-4 is a compression method by
means of which large quantities of data can be reduced without any
noticeable loss of picture and sound quality.
NOTE:
It is not possible to guarantee full compatibility with all of the com-
pression methods used worldwide, particularly when more than one
soundtrack or subtitles are involved. Also MPEG 4 fi les with integrated
special functions such as a menu, subtitles etc. are not always sup-
ported. This is no malfunction of the player.

Playing media

You transmit commands to the DVD-Player via remote control. It is thus
important to point the end of the remote control towards the DVD-
Player.
NOTE:
If the device is not yet in DVD mode, press the SOURCE SELECT (Fig.
3/8) button on the remote control repeatedly until „DVD" appears in
the display.
1. Press the remote control button OPEN/CLOSE (Fig. 3/1). The CD/DVD
tray opens.
2. Place the CD/DVD on the tray.
3. Press the remote control button OPEN/CLOSE (Fig. 3/1) again. The
CD/DVD tray closes. The display (Fig. 1/5) fi rst shows „LOAd". After a
short while the type of the loaded medium is displayed (e.g. „DVD").
When playing CDs the following status information is displayed on
screen:
Current track/total number of tracks (1).
Time (2): This provides information about the duration and the re-
maining play time. By standard the play time expired of the current
track is displayed. The display is in hours, minutes and seconds. Press
the OSD-button (Fig. 3/7) once or several times to have further times
displayed.
The following possibilities are available for selection
- time remaining to the end of the track,
- playback time of the CD so far,
- time remaining to the end of the CD.
English
61
24.06.2010 16:48:52 Uhr 24.06.2010 16:48:52 Uhr