Audio-/Video Cords; Connecting The Video Cable - AEG DVD 4625 HC HDMI/USB Bedienungsanleitung

English
56

Audio-/Video cords

Connecting the Video cable

Fig. 2/18
05_DVD 4625 HC AEG - GB.indd 56 05_DVD 4625 HC AEG - GB.indd 56
1. Open and remove the battery compartment cover.
2. Insert two batteries of type AAA/R03 (1.5 V), ensure correct polarity
(+ and -). Start with the negative pole (-).
3. Attach and close the battery compartment cover.
NOTE:
The signals from the remote control are transmitted to the DVD-Player
by infrared light. You should therefore take care that the DVD-Player is
not exposed to the direct sunlight. This could make the transmission of
signals from the remote control to the DVD-Player impossible.
Eff ective range of the remote control
If you want to use the remote control it has to be pointed at the remote
control sensor on the front of the device. The distance between remote
control and sensor should not exceed 7m. The angle of the remote con-
trol to the remote control sensor to right, left, top and bottom should
not exceed 30°.
NOTE:
An undisturbed operation can be guaranteed only with Audio/Video
lines up to 1.5 m length.
The video cable transmits the video data from your DVD-Player to the TV
or the Video-Projector.
There are fi ve diff erent ways of connecting the DVD-Player with your
TV/Video-Projector. Select one of these possibilities to suit your replay
unit.
NOTE:
If you are not using a SCART or HDMI connection you must always
establish an additional audio connection for transmitting the audio
data (i.e. the sound).
SCART
SCART is used to transmit both Video and Audio data.
1. Plug the SCART jack fi rmly into the socket on the back of the player.
2. Plug the SCART jack into the corresponding socket on your playback
device.
24.06.2010 16:48:50 Uhr 24.06.2010 16:48:50 Uhr