Operating Controls - VOLTCRAFT HPS-11530 Bedienungsanleitung

Three freely programmable memory slots can be assigned to different fixed voltages and current limita-
tions. The selection switch is located at the back of the device.
The device is overload- and short-circuit-proof and contains a safety temperature cut-off.
The laboratory power unit is designed in compliance with protection class 1. It is only approved for
connection to shockproof sockets with protective grounding and an alternating current of 230V/AC com-
monly used in households. .
Operation under adverse environmental conditions is not permitted. Unfavourable ambient conditions
are:
- moisture or high humidity
- dust and combustible gases, vapours or solvents
- thunderstorms or similar conditions such as strong electrostatic fields etc.
Any use other than that described above damages the product. Moreover, this is linked to dangers such
as short circuits, fire, electric shock, etc. No part of the product may be modified or rebuilt!
Observe the safety instructions under all circumstances!

Operating Controls

See fold-out page
(1) Power switch for putting the device into operation (I=ON / 0=OFF)
(2) Voltage display "V"
(3) Current display "A"
(4) Status display output "C.V. (constant voltage operation)
(5) Status display output "C.C. (current limiter/constant current operation)
(6) Status display "REAR CONTROL" shows active remote control or fixed voltage operation
(7) Voltage control (with button function for coarse / fine adjustment)
(8) Current limiter control (with button function for coarse / fine adjustment)
(9) Minus pole connection socket (max. 5 A!)
(10) Plus pole connection socket (max. 5A!)
(11) Plus pole high-load connection (screw clamp with socket function)
(12) Minus pole high-load connection (screw clamp with socket function)
(13) Slider for selecting the 4 operating modes "MODE"
(14) "SENSE" remote sensor connection (HPS-11560 only)
(15) Slider for selecting the freely definable fixed voltage places "RECALL"
(16) Remove control connection "Remote Control"
(17) Temperature-controlled internal fan Do not cover!
(18) Grounded low-power connection for mains cable
(19) Fuse holder for the mains fuse
27