Wetelux 84 26 92 Bedienungsanleitung Seite 15

Intended Use

The LED floodlight is intended for illuminating house entrances, drive-
ways, etc. It may be installed in outdoor areas (taking into account the
installation location!).

Any other use than that described above may damage the product.
Moreover, this may give rise to hazards such as short-circuiting, fire,
electric shock, etc.

No part of the product may be modified or converted!

The safety instructions must be observed at all times!
Preparations for Installation

The product may only be installed by a qualified technician (e.g. electri-
cian) who is familiar with the relevant regulations (e.g. VDE, German
electrical wiring regulations)!

Improper work, carried out on the mains voltage, endangers not only
your own life but also the life of others!

If you do not have the expertise required for the installation, do not
install it yourself but ask a qualified technician.

Observe the safety instructions!

Without fail, pay attention to the correct mounting position of the LED
floodlight and the connection cable. If installed outdoors, make sure no
water can enter the housing when installing the connection cable.

Only install the LED floodlight on a stable surface. Use screws and
plugs that are suitable for the surface.

The LED floodlight must be protected on the sub-distribution board by a
10/16A fuse. An earth leakage circuit breaker must be installed before
this (FI protective switch).

The LED floodlight must be disconnected from the power supply during
installation. It is not sufficient to just turn off at the light switch!

Turn the power off by removing the corresponding circuit fuse or switch
off at the circuit breaker. Secure it against an unauthorised re-start, e.g.
Using
11